MODELS RMIP33 AND RMIP45INTENDED FOR DOMESTIC COOKING ONLYINSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER.HOMEOWNER: USE AND CARE INFORMATION ON PAGES 12
- 10 -16. DUCTING CONNECTION (ALL BLOWERS)A. When there is access to the top of the hood, connect ductwork and seal connections with duct tape after S
- 11 -Secure the blower by installing 2 more no. 8 x 3/8’’ screws for the P5 blower and 4 more no. 8 x 3/8’’ screws for P8 intothe locations shown in
- 12 -Grease filters and impeller(s).The grease filters, impeller(s) and grease rail should be cleaned frequently. Use a warm detergent solution. Grea
22. OPERATIONBLOWERThe blower is operated using two (2) controls or with the RMIPWC optional wall control.Use the red, lighted on/off switch to start
KEY PART MODELNO. NUMBERDESCRIPTION33 45RANGEMASTER LOGOFILTER CLIPTHERMOSTATSPEED CONTROLSCREW NO. 8-32 x 1/2’’, QUADREXMALE CONNECTORFEMALE CONNECTO
KEYNO.PART NUMBER DESCRIPTION QTY.- 15 -SERVICE PARTS1234567891011121314151617181920212223SV13296SV03500SV12997SV03577SV02160SV01869SV01857SV01582SV1
212223232024251191817161513691011121445KEYNO.PART NUMBER DESCRIPTION QTY.12345678910111213141516171819202122232425SV14971SV13296SV03500SV14975SV03577
WARNING WARNING- 2 -TO REDUCE THE RISK OF FIRE, ELECTRICSHOCK OR INJURY TO PERSONS, OBSERVETHE FOLLOWING:1. Use this unit only in the manner intended
HL0067- 3 -RMP Series Backsplash(Stainless Steel wallcovering with warmingshelves. Optional)RML3336S, RML3342S,RML4548S, RML4554S orRML4560SCustom Hoo
- 4 -HL0068RMP Series Backsplash(Stainless Steel wallcovering with warmingshelves. Optional)RML3336S, RML3342S,RML4548S, RML4554S or RML4560SCustom Ho
- 5 -1. SELECT BLOWER OPTION AND INSTALL DUCTWORKEither an interior or exterior blower or in-line blower may be used with this insert. The insert mode
- 6 -3. INSTALL BACKSPLASH (OPTIONAL)It is recommended to install the backsplash before the custom hood insert. The custom hood will cover the backspl
- 7 -8. CUT THE HOLE IN CUSTOM HOOD BASEIf it is not done yet, cut a hole in the bottom of the cabinet, usingthe dimensions shown beside. NOTES : 1. T
- 8 -11. INSTALL THE DEVIATOR (INTERIOR BLOWER)Install the deviator as shown.NOTE : To prevent the deviator from sliding out of the rough-in plate, pu
- 9 -13. CONNECT WIRING (ALL BLOWERS)Connect cable into wiring box using provided wire connectors.Connect wires as follow: BLACK to BLACK, WHITE to WH
Komentáře k této Příručce